Roof Coating Energy Saver Impregnations Facade Paints Contact

SREP Facade

SREP Facade

Product description:
Full matt and weather resistant siloxane/acrylic emulsion façade paint with high covering ability

Product properties and use:
SREP Facade is used on mineral surfaces such as concrete, set silicate, and rendered façade constructions - also previously painted surfaces.
The paint is dirt-resistant and water-repellent and after drying it leaves behind a diffusion open surface. Not to be used on flexible surfaces.


Technical data

Composition:
Siloxane/acrylic emulsions

Colours:
Anthracite grey, light slate grey, light grey, white, cream white, light yellow, sand – tinted pastel colours are available on demand

Packaging sizes:
9 l

Density:
1,5 kg/l

Dry content:
Approx. 64 weight %, approx. 46 vol. %

Gloss:
3 at 60°

Water vapour diffusion thickness:
Sd value: 0,18 m (V2 medium)

Water absorption:
W value: 0,11 kg/(m2H0,5) (W2 medium)

Spreading rate:
3,3 - 6,5 m2/l

 

  Theoretical spreading rate 

 Recommended layer thickness, each layer 

Wet 

Dry 

6,5 m2/l

150 µm

70 µm

  Recommended layer thickness of finished coat 

3,3 m2/l

300 µm

140 µm

The practical spreading rate depends on application method, form and surface of the material.

Pre-treatment/cleaning:
The surface must be clean, dry, and sustainable. Clean dirty surfaces with Iso A-Clean according to instructions. If facades of brick tiles and sand-lime bricks are treated, they must be frost resistant. Repair damages, if any, with mineral materials suitable for this purpose. Ensure that there is no damp and efflorescence on the façade.

Very absorbent surfaces must be primed with SREP Facade Primer according to instructions.

Stirring:
The paint must be stirred before use.

Dilution:
Normally, to be used undiluted. If the surface is not primed, dilute with 10 % water for the first application.

Application temperature:
The temperature must be between 8° C and 30° C and 85 % RH.

Application method:
Sprayer, roller, or brush

Apply Iso Silicone Façade paint once or twice until the façade has a matt and uniform look. The first layer may be diluted with max. 10 % water. Apply the second layer undiluted.

Please note: Do not apply in direct sunlight

Always make a test coat to ensure the compatibility of product and surface.

Drying time:
Laboratory tests

 Wet layer thickness 150 µm 

 20 °C / 65 % RH 

Touch dry

1 hour

Recoatable

6 hours

Fully cured

1 - 2 weeks

The drying and times for recoating depend on layer thickness, temperature, relative air humidity, and air circulation.

Cleaning of equipment:
Water and soap

Storage:
Cool, protected from frost, in tightly closed packaging, and out of reach of children

Environment:
No spillage into drains, to be disposed of at the local recycling centre

VOC: Max. 40 g/l (Kat. A/c)

Iso Silicone Facademaling

Energy Saver

 

Iso Silicone Facademaling

Iso Silicone Facademaling

Iso Silicone Facademaling

Iso Silicone Facademaling

 

ISO PAINT NORDIC A/S · Tværvej 8 · 6640 Lunderskov · Denmark · © Copyright Iso Paint Nordic 2014
SUPPORT · Telefon +45 76 33 31 14 · Mail: mail@isopaint.dk